Quite often in residential apartments and offices you can find the decoration of walls and ceilings with plastic panels. And this is not at all surprising, because this material is quite inexpensive, good in operation and retains an excellent appearance for a long time. And it's incredibly easy to work. Even a person who works with him for the first time is unlikely to have any difficulties.
But the shops mostly sell panels with a length of 2.4 meters. Therefore, during the repair, you have to cut the panels to the required size yourself. And the question arises: "How do they cut plastic panels?"
Knife
You can also use a simple knife, only after sharpening it as best as possible. Although this is not the best solution, or rather, the most unfortunate. After all, the cutting method is poorly suited for cutting panels. But still, this tool will eventually also cope with the task.
It is convenient to cut the panel with a clerical knife. Fora cut is made at the top along the line, and then the material breaks.
Or you can make a knife yourself: cut a piece of cast steel on one side at an angle of 45 degrees and sharpen it, and wrap the handle with tape to make it comfortable to hold.
But it is more convenient and safest to purchase a special construction knife. Among all the answers to the question of how plastic panels are cut, the last one is the most suitable.
Saw
If a wood saw is used, then the teeth should be for transverse or mixed sawing, and better not set, then the plastic will be cut neatly and evenly. Therefore, a saw is not the worst answer to the question of how plastic panels are cut.
Bulgarian
Bulgarian is a good option for working with panels. But there is one important nuance: you need to work extremely carefully with this tool, because plastic is an incredibly fragile material and there is a chance that it will break. After cutting with a grinder, it is necessary to grind the corners with a special machine. If it is not found in construction equipment, it is better to look for another way.
Power tool
If someone is wondering how to cut plastic wall panels, and there is an electric jigsaw among the tools, then you can discard all doubts and apply it. After all, this is one of the power tools that is suitable for this task. But first you need to try to cut an unnecessary piece. And all in order to understandwhich side will be cut neatly. There is also an important detail: the file must be with a fine tooth, and the pendulum stroke is disabled. So, paying attention to all the recommendations, you can cut the panels without difficulty. Moreover, this method saves a lot of time, because with the help of an electric jigsaw you can cut several panels at once, simply by folding them evenly together.
Hacksaw
But often for those who think about how to cut PVC plastic panels, the choice falls on a hacksaw for metal or wood, but it is important that the teeth are small. The advantage of this method is that you can cut several panels at the same time. It is necessary to cut with the front side, at a slight slope and try not to press hard on the material.
Rules for cutting panels
If the panels are just brought from the street, especially if the temperature is low, in this case you can not immediately start work. They need to warm up for a while, as they become even more brittle when cold and can easily damage the material.
Before you start cutting, you need to mark where the cuts will be. A felt-tip pen is best suited for these purposes. It is clearly visible on the panel and can be easily erased later.
During work, one should not forget about safety precautions, it is better to wear gloves and goggles. The thing is that when breaking, the panels form very sharp fragments, and there is a danger of getting hurt by them.
And in general, this material is very fragile, so it is necessary to work with it verycarefully and carefully.
So if someone else is asking themselves, "How do they cut plastic panels?" - then we can safely say that there are many options. And surely in the end there will be the most suitable one.
