Non-woven wallpaper is very popular today. For example, everyone knows vinyl products, which are characterized by a wide variety of color combinations and patterns. The basis of such wallpaper is interlining. With proper spraying of vinyl, the material retains the ability to pass air. And it can also have a beautiful relief that will make the room original and cozy.
Non-woven wallpaper has a large number of advantages. For example, some types of material can be painted in any color, so you can quickly freshen up the room without removing the glued finish. Naturally, the repair time is significantly reduced. When sticking such wallpaper, there is no need to apply a substance to the material itself. You just need to smear them on the wall. In some cases, a thick wallpaper base can eliminate minor irregularities and defects on the base surface. And they can also be glued in technical rooms. The fact is that non-woven wallpaper is not susceptible to moisture, does not swell and does not peel off. Therefore, they can be used for bathroom renovation orkitchens. In addition, the basis of the wallpaper is very durable, as it is made of cellulose fibers.
Very popular are non-woven Rasch wallpapers. They favorably differ in excellent quality, increased safety and aesthetics. The presented material is manufactured using the most modern technologies. A lot of specialists work on the creation of the design of each wallpaper model.
The presented material is very practical, but it must be pasted correctly. Working with him is not so difficult if you know some of the nuances. Once again, it should be repeated that it is necessary to glue wallpaper on a non-woven base on a prepared base. The canvas itself should not be smeared. Glue must be diluted strictly according to the instructions, in addition, you should choose the right substance for this particular type of material.
During work, be very careful not to get glue on the pattern of the canvases. You can start the gluing procedure from any angle. The fact is that the canvases should be joined end-to-end. The very first strip should be attached as evenly as possible. In the corners, it is often necessary to glue the canvases with an overlap. However, it must be optimal so that the edges of the strips do not protrude. If wrinkles still appear on the treated surface, then the wallpaper needs to be cut and smoothed.
Sticking wallpaper on a non-woven base with a three-dimensional pattern requires their alignment with a soft roller. The sequence of work is very simple. At firstwe cut off the canvas of the required length from the roll, then we smear the wall with glue and apply the strip to the surface. Using a roller or rubber spatula, smooth the wallpaper tightly, but carefully. And we do it so that the excess glue comes out in the direction where the strip is not yet attached. In this way we carry out the whole procedure. That's all the features of working with non-woven wallpaper.
