Many drivers strive to make their car better, eliminate existing, in their opinion, shortcomings. And they do it with the help of self-made homemade products for cars. In this article, we will consider only a few examples that the authors have posted online.
USB socket
A variety of electronic homemade products for cars are popular with drivers. A good example is a USB socket placed at hand. Using a cigarette lighter is not always convenient. And the option under consideration should be pleasant.
The basis will be a USB socket, which can be purchased on the market. The first step is to take it apart. The entire plastic case must be removed. To work, you need only the core. A cover is cut out of any piece of plastic on the outlet. It should fit in size to the hole in which the socket will be placed in the future. A rectangular cut is made in this cover to fit the socket inlet. If the outlet is with an LED, you need to make a hole for it. The edges are smoothed out with sandpaper to make everything look more aesthetically pleasing. For the same purposeplastic can be pasted over with vinyl or self-adhesive paper.
You need to solder a wire to the printed circuit board of the port, the second end of which will be connected to the cigarette lighter. Metal clips are attached to the back of the plastic. With their help, the device is mounted in the console slot.
12V air conditioner
Do-it-yourself crafts for cars involve making useful things from what is at hand. So, from radiators from a desktop computer, you can assemble an air conditioner, the size of which will be 5x5 cm. Its power is 30 W.
You will need two radiators. To the place where the cooler is larger, the Peltier element is attached with the help of hot glue. The smaller radiator is glued on the other side. The whole structure is connected to the power supply. The peculiarity is that the air from the coolers should go in different directions. There will be a cold stream on one side, and a warm one on the other.
Adhesive gas cap
Many drivers know the problem of losing the gas tank cap. And do-it-yourself homemade products for cars will allow you to solve it. Make it easy. It is necessary to place a small but strong magnet inside the lid. A neodymium magnet from a hard drive will do. Half will be enough.
Rear speaker shelf
Do-it-yourself homemade products for cars will also help if you need to install rear speakers, but there is no shelf. In this case, the shelf is made from ordinary chipboard sheets.
The size of the sheet will depend on the modelcar, but the approximate parameters are 110x45 cm. The thickness will be enough 2 cm. The chipboard sheet is cut into two parts. One of them will go up. The second will serve as a support for the speakers. Moreover, the second part will be wider (about 40 cm). To prevent moisture from getting into the sheets, they need to be varnished.
From the same sheets of chipboard, you need to cut stands for speakers. To begin with, a template is applied (existing speakers are used for this). Similar holes are prepared on the shelf itself. The podiums are fixed with the help of holders (they will need 4 pcs.). Holders can be cut from the remnants of chipboard. The angle of inclination is chosen arbitrarily. The parts are connected with self-tapping screws. They can be smeared with glue beforehand.
In order for the podiums to be voluminous, polyurethane foam is used. With its help, the desired volume is created in several passes. After drying, the foam is cut off. Irregularities are puttied and rubbed with sandpaper. Next, you need to check whether the speakers fit correctly into the prepared holes. If all is well, then the workpiece can be pasted over with a cloth. It is enough to sheathe only from the front side.
Two shelves are connected using conventional canopies. Speakers are connected from below.
Homemade for cars, made by hand, will be useful creations. Plus, it's always nice to see the results of your own work.
