In fact, all types of wallpaper are identical, but it would not be right to apply the old norms to new types of materials, for example, to vinyl wallpaper. This can lead to their damage, which is highly undesirable. So, if you are concerned about the question of how to glue vinyl wallpaper, then it will be discussed further.
Before proceeding with this operation, you need to make sure that the wallpaper received the right article, and that the rolls have a single batch number. It is worth sticking two or three strips, and then carefully check them for defects. If a defect is found, contact the supplier immediately and the work must be stopped.
If we consider the question of how to glue vinyl wallpaper, then it should be said that at the first stage you need to start preparing the walls. They should be made smooth, even, clean and dry, peeling paint, signs of mold, grease, andfrom old glue.
If the walls have just been plastered, it is important to let them dry before applying a primer coat. An important condition is that all walls are primed before gluing. Water-based paint is completely unsuitable as a primer.
Vinyl wallpaper: how to glue
Now you should prepare the strips. This is done as follows: it is necessary to cut off two canvases that are equal to the height of the ceiling in the room, while it is necessary to take into account the fit of the pattern and allowances of 5-10 centimeters for each of the strips. The strip should be cut off from the roll only after the pattern on the sheet has been adjusted until it matches completely. Each cut strip should be marked with a pencil in order to avoid confusion later.
And now we come close to the question of how to glue vinyl wallpaper. The strips must be glued strictly in the order in which they were cut from the roll. The first one needs to be glued on a plumb line. Cutting wallpaper on the floor and ceiling should be done with a spatula using a fairly sharp knife. Glue should not get on the joints of the wallpaper. If it gets on the surface of the sheets, it must be removed immediately with clean water and a sponge. Wallpaper along the edges should not be rubbed, as dried glue can damage their surface. It is worth immediately getting rid of it if it got on the platbands and baseboards. Glue should be applied to cut sheets. This concerns the question "how to glue vinyl wallpaper on a paper basis." However, there is another type of base - non-woven. ATIn this case, the adhesive must be evenly applied to the surface of the wall, after which it can be glued.
When the process is completed, you need to make sure that the wallpaper adheres to the surface firmly enough. It is worth saying that the described rules can only be called advisory, since they do not take into account all the nuances and features of the work. If you trust the experts in the matter of "how to glue vinyl wallpaper", then they will take full responsibility. If you took up the work yourself, then you should do everything very carefully in order to prevent negative consequences.
