Strong popularity among the consumer has recently gained such building material as corrugated board. It is readily used for fencing sites, building warehouses and roofing. It is also in demand among car owners for the construction of garages. To build a garage from corrugated board with your own hands, you do not need large material costs, in addition, the profile is easy to assemble, it is durable and outwardly wins due to a wide variety of colors. Polymer-coated metal profile sheets last up to forty-five years, they do not need constant painting and special care.
It is necessary to start building a garage from corrugated board with your own hands from the foundation. It can be tape or columnar. The floor in the garage is made of concrete, with a simultaneous installation of a viewing hole. The basis of the building is a metal frame,the supports of which are installed at the time of laying the foundation and simultaneously poured with concrete. After the supports are installed around the entire perimeter of the future garage, transverse pipes are screwed to them with self-tapping screws. Sheets of corrugated board are attached to the frame with self-tapping screws, and the correctness of their installation is checked using a level. To prevent scratching the profile sheets, rubber gaskets are placed under the screws, and to improve the tightness, the joints of the flooring sheets are fixed with rivets. The distances between the racks of the frame should be equal to the width of the metal sheet, which will greatly simplify installation and save you from unnecessary work on cutting the profile. A corrugated garage is often insulated with mineral wool. You can use other heaters.
A garage made of corrugated board, built with your own hands, involves the installation of a single or gable roof. The simplest, and therefore often used, is a pitched roof. On the rafters from the corner or pipes, which are installed simultaneously with the frame, sheets of metal profile are fastened with self-tapping screws. After laying the profile, all joints are sealed with sealant.
A do-it-yourself garage from corrugated board is built quickly enough, almost every car owner can do it. One or two assistants are enough - and in a couple of days the garage will be ready.
As already mentioned, corrugated board is very popular for erecting fences, and since there is a fence, then a gate and a gate are needed. Do-it-yourself gate from corrugated boardmounted on load-bearing poles, which can be made of metal pipes or bricks. Pipes are installed in a pit with a depth of at least one meter and poured with concrete. If the pillars are brick, then a light foundation is made under them. After installing the supports from pipes or a corner, the frame of the gate is welded according to predetermined dimensions. A pipe is welded into the middle of the frame. Sheds are welded to the finished frame, as well as to pillars and supports, and a lock is cut into the frame itself. The corrugated board is fastened to the finished frame with self-tapping screws, and a hole is cut out in the place where the lock is installed. After installing the door handle, the gate is hung on a support to check its operation.
