Durability, safety, unlimited scope, implementation of the most creative ideas - this is not a complete list of the advantages of a finishing material available to everyone. Self-adhesive film will drastically change the look of your furniture, room walls, bathroom, doors or windows in no time.
Agree, you can buy a suitable film with any budget, even the most modest one. Whereas renovating bathroom walls with a few cracked tiles or buying new furniture can be costly and time consuming.
Self-adhesive film under the tree is in the greatest demand among the population. The classic pattern is easy to pick up for pasting panels, "apron" at the kitchen sink, interior doors, student tables, stools, cabinets. The color range of patterned "self-adhesives" ranges from colorless stained glass to "metal", "marble",fantastic, floral, geometric motifs.
Starting pasting furniture, windows, anything, use simple tips:
1. Training. The self-adhesive film is easy to apply. Before you start gluing, you need to prepare the base: clean it from dust and grease stains, if any. An uneven, rough surface is best covered with a primer.
2. Cutting. On the reverse side of the film, on its paper basis, a centimeter scale is applied in the form of a grid, which, of course, greatly facilitates the cutting process. Just cut off the desired fragment along the intended line.
3. Pasting. Carefully separate the paper base by 5 centimeters from the film. Gently apply the adhesive side to the prepared surface. We smooth the glued film with a soft rag from the middle to the edges. Then again we tighten the paper from the back of the "self-adhesive" for a short distance and continue gradual gluing with smoothing.
Very convenient self-adhesive film for furniture.
4. Error correction. Pasted wrong? No problem! Self-adhesive film is easy to adjust, because the final bonding will occur after a few hours, so feel free to remove the decorative material and make an accurate "fit".
5. Advice. If the self-adhesive film is excessively tacky and difficult to work with, powder the surface to be treated with talcum powder to make it easier to fit.
6. The bubbles formedfilm, pierce with a pin and smooth the coating with a towel or soft, clean cloth.
7. The process of pasting metal surfaces and glass has some differences. The window (or metal) must be moistened with a solution of water and a small amount of detergent. From the prepared “pattern” of the film, completely remove the paper base and lay it on a damp surface. Next, the familiar process of smoothing with a sponge while simultaneously evacuating water from under the film.
8. Care. The glued surface should be wiped with a damp cloth. If the contamination cannot be removed in this way, a solution of water and detergent or an alcohol solution can be used.
