With the advent of spring, you often spend your time in the country or in the garden. A trimmer will protect you from problems such as grass and weeds. This tool effortlessly trims and mows grass in difficult areas where a conventional lawn mower cannot do it. The trimmer is a very efficient and handy tool for cutting grass along fences, flower beds, houses and garden aisles. Several types of garden trimmers have been invented (gasoline, electric and battery). It would seem that everything is fine, in your arsenal there are
s such a wonderful helper, but over time, the cutting element wears out and it becomes necessary to replace the finished fishing line. And how to fill the fishing line in the trimmer, not everyone knows. We suggest using the step-by-step instructions with attached photos.
Instructions on how to wind the fishing line on the trimmer spool
- 1. First you need to disassemble the trimmer head. Press the latch onbody of the product and turn the cover clockwise. Removing the bobbin.
- Now we have to figure out how to wind the line on the trimmer spool. We measure about 6-7m of fishing line and insert its end into the bobbin hole.
- We wind the fishing line on both sides. The direction of winding is always indicated on the bobbin as an arrow.
- Leave the ends of the cutting element 15 cm long free. Do not wind too much fishing line. Leave 6 mm between the outer edge of the bobbin and the line.
- Insert the remaining two ends of the fishing line into the opposite holes of the bobbin.
-
refilling the line in the trimmer Fix both ends into the grooves on the head body.
- The spring is carefully installed back into the bobbin guides and into the head housing.
- In order for the threading of the line into the trimmer to be correct, it is necessary that the bobbin enters back into the body of the head (press it lightly). If necessary, pull the free ends of the fishing line out. One by one, sharply pull the ends of the cutting element so that they come out of the grooves of the bobbin and freely pass through the holes on the head.
- So, we figured out how to wind the fishing line on the trimmer spool. It remains only to combine all the grooves on the head body and close the cover. Then we press the bobbin and begin to rotate it counterclockwise until it stops. While holding the bobbin, turn it slightly clockwise and release it. If a clicking sound followed, then it snapped into the head. If this did not happen, then you need to repeat the action again.
- Pull out the free ends of the fishing line until it stops.
A few tips
In this article we figured out how to wind the fishing line on the trimmer spool. And if you did everything right, then when you press and hold the bobbin, it should pull out again. A trimmer line is a very important element, without which the tool loses its functionality. In fact, this is the heart of the trimmer. Therefore, make a purchase in a specialized garden equipment store and approach the choice with special attention. When buying a new line, be sure to compare it with a piece of an old, used cutter.
