As a rule, in rural areas, in small villages and villages there is no centralized water supply. Sooner or later, every summer resident wonders how to make plumbing in the country. After all, even a well in the yard of your own house does not solve all problems with water supply. The answer is simple: using an electric pump, it is quite easy to create an uninterrupted water supply in the country.
If there is a well, well or any reservoir nearby, as well as if there is a source of electricity, you can provide water supply in unlimited quantities. In order to create a water supply system in the country, you need to draw up a detailed diagram of it. There are two options: summer and winter water supply in the country. If people live in the country all year round, then the elements of the winter water supply system simply need to be taken into account when designing the water supply system. And then, for the device of the water supply system, it is worth purchasing a pump or pumping station, a hydraulic accumulator with a pressure switch, pipes, fittings, filters, and valves. The scheme of operation of such a water supply system is simple. The submersible pump is installed in accordance with itsinstruction manual.
Water from the well is supplied through a pipe installed at an angle. This is done so that the water flows out of the system by gravity. This is especially important in winter, as when the water freezes, it expands and the pipe may burst. For the same reason, the supply pipe is often carried underground into the house. The depth of laying the pipe in the ground should be below the freezing depth of the soil in the area. For plastic pipes, the laying depth is chosen no more than half a meter, in addition, the pipes are insulated with a twenty-thirty-centimeter layer of insulation. Before the pump, you need to install filters for coarse and fine water purification. Thanks to them, the water supply system will last longer, and the water supplied will be cleaner.
Intra-house plumbing system - dead end. You can set the desired number of taps for water analysis and other devices. When any of the taps opens, the pressure in the water supply begins to decrease. As soon as the water pressure in the system drops to a certain level, the installed relay will turn on the pump or pumping station, which will work until the pressure in the system is restored. Then the relay turns them off. From the storage tank, water through the pipes can go by gravity. At the same time, the pressure in the system is small, but some devices will not be able to work at low pressure. To solve this problem, another pump is built into the system. The internal water supply system includes filters that purify water, andstop valve. The storage tank can be installed in the basement if the water supply in the house is arranged using a pumping station. If a pumping station is not provided for in the water supply system, then the storage tank is installed in the attic. In this case, the supply pipe is brought to the attic on top, and it must be insulated. In general, many summer residents prefer a submersible pump, since pumping stations are very noisy. Or a pumping station is installed outside the house. Then the room for the pumping station needs to be insulated quite seriously. To obtain hot water, a boiler is built into the system. This is how you can arrange water supply in the country.
