Probably every second person would like to have their own pool. And most owners of private houses have such an opportunity. Many have become accustomed to the stereotype that such an idea requires a fairly large investment. But in fact, this is not entirely true. An excellent inexpensive solution would be to install a frame pool. This option is more than affordable. Even those who have a dacha near water bodies do not always have the opportunity to swim. Since not everywhere there are clean water bodies, but in the hot summer everyone wants to be able to cool off a bit in cool water.
In a traditional frame pool, steel components act as supporting walls. A strong film should be placed on top of the parts, the necessary plastic sides and water filtration devices.
It is very easy to change water. At the bottom there is a special tap to which you need to connect a hose, dirty water will flow out of it. For maximum benefit of this design, you can use the spentwater for watering plants, vegetable garden or garden.
This article will provide general instructions for installing a frame pool. This job requires a minimum of two people. The more people involved in the construction, the faster and easier the expected result will appear. The pump should be installed at the end of the entire assembly. The pond should be placed on as flat a surface as possible. It should not have any stones, knots, small depressions and other similar things, as all this can lead to damage to the material. It is better to save the storage box, it can be useful for reassembly and further storage in the winter. Installation of the frame pool "Intex" should take place on the litter. It is better to prepare the site in advance. Above it is the base of the pool (fabric). You need to pay attention to the direction of the drain hole, because in the future you will need to send water to the required place.
The drain valve is removed from the hose and waiting for the fabric of the future design to heat up. Then you need to insert the beams into the passages intended for this. It is very important not to move the material on the ground, because tissue may be damaged. Therefore, the installation of the frame pool should immediately be carried out at the place of further use. The location of the reservoir should be at a distance of the full length of the extended pump cable from the outlet (it is strictly not recommended to put a pool right next to it). The horizontal beam must be inserted into the hole prepared for this,then connect it to the T-joint with a bolt and rubber seals. Installation of the frame pool in this mode should take place in one direction. At the end of the contour alignment, it may be difficult to connect the parts. To do this, it is recommended to raise them by 5 cm and lower them at the same time, connecting at the same time.
There are many subtleties of assembly, and it is recommended to follow them all. The work may seem somewhat laborious, but the result will exceed all expectations. The re-installation of the frame pool should be carried out confidently and automatically. Today it is one of the best, inexpensive, but high-quality pool options.
