A well for a country house is one of the best options for providing water. If its depth is more than 6 meters, it is necessary to use a special device. The owners are faced with the question of choosing a product according to certain parameters.
Depending on the purpose, the pumps are divided into water-lifting, circulation, drainage. The most common are surface devices. They are purchased due to their low cost and ease of use. Ground water is pumped out by drainage pumps. If water is extracted from a deep well, a submersible unit, such as the Rodnichok pump, should be purchased.
This appliance can work even with a weak power grid and a low-power generator. It is made of stainless steel. If the water is deep enough in the area (more than 10 m), only submersible pumps can be used. They, in turn, are divided into centrifugal and vibration.
The Rodnichok pump should only be used if the well is located in sandy soil. A current passes through the coil winding, as a result of which a magnetic field is formed, attracting the steelcore. The diaphragm then bends and the volume of the chamber increases. The magnetic field stops, the diaphragm flexes and the water is pushed out.
The vibration pump "Rodnichok" can lift water from a depth of 20 meters. This product consists of an electromagnet, a U-shaped core and a winding. The prices for these units are low. Before choosing a device, you need to know about its advantages.
The "Rodnichok" pump has the following advantages:
- made of high quality alloys;
- safe;
- economical;
- easy;
- inexpensive;
- possesses a significant resource.
Recommendations for product installation
First, you need to pump or clean the well. For pumping, you need to drain the water with sand. You can also make a barrel with a sand catcher. That is, two taps are mounted in it: water enters the lower compartment from the well, and it pours out from the upper section. In this case, the sand settles at the bottom of the barrel. Another reliable method is cleaning, but it is more laborious. After the procedures, you can install the pump "Rodnichok".
The next step is to connect the water pipe to the outlet of the device. The size of the pipe is chosen depending on the depth of the well. A sleeve is put on it to protect it from deformation.
Submersible pump "Rodnichok" during operation should not touch the walls of the well, so a rubber ring is installed on it. Many models of submersible unitshave a float switch. High-quality devices are made of stainless steel, while cheap analogues have a case made of plastic.
Installation steps
- Measure the distance.
- Prepare an electrical cable that matches the size.
- Connect the cable to the pump.
- They install the pipe to the unit.
- The device is tied with a stainless steel cable.
- Lower it into the well.
- Cut the casing.
- They bring water into the house.
In order for water to flow smoothly, it is necessary to invite specialists. They will measure the depth of the well, make accurate calculations and give recommendations on the purchase of the necessary device for the well.
