Any room, regardless of its purpose, requires periodic repairs. Laying electrical wiring is a very important stage of construction and repair work, so before you start chasing surfaces, you should agree on several important issues with family members, the designer, clarify the established standards and the possibility of implementing the desired requirements in practice.
Regulations
The location of lamps, chandeliers, sockets, switches must be agreed in advance with those people who make the design part of the room and participate in their daily use. In addition, the customer of the work must have a permit that is issued by the relevant authorities, since the construction documentation contains standards that cannot be violated during construction work related to wall chasing.
How to wire a house if its walls are concrete? monolithicconstruction technology and brickwork, the thickness of which exceeds 30 cm, allow for chasing. In a panel house, such work is prohibited. But users have the opportunity to replace the electrical wiring using the strobes or plastic boxes available in the panels.
Punch
Groove surfaces can be carried out with various construction tools. When working with brick and concrete walls, specialists use a puncher, but before starting work, they make markings.
The marking of the wiring route is carried out after the complete approval of the locations of the end devices. Chasing for wiring occurs by drilling holes, the pitch of which does not exceed 2 cm, and connecting them by switching the puncher to the "hammer" mode. Partitions are removed at an angle of 90 ° with respect to the axis of the holes obtained.
Specialists, before stretching the cable, install switches, boxes for sockets. This is followed by the stage of closing the strobe.
Bulgarian
How to conduct wiring in the house, if there is only a grinder among the building tools? You need to take care of the presence of a diamond disc. In tandem, a construction tool is obtained, with the correct use of which it is possible to punch a wiring route. But without a perforator, in this case, nothing will work.
Before starting work, the surface must be plastered. Surface chasing occurs earliermarked trails. The grinder cuts the furrows, and the section of the wall between them is removed with a puncher in the “hammer” mode. Using this method, even, quality edges can be obtained.
Walker cutter
The chasing of surfaces with this tool is the best method for obtaining high-quality results in a short time without dust. A high level of strobe reduces the cost of additional work.
Compared to a hammer drill and grinder, physical effort is minimal when a wall chaser is used. This tool in tandem with an industrial vacuum cleaner allows you to perform high-quality chasing. The price of services (and this is usually $ 1 per meter of strobe done) ceases to interest customers after they learn that all work will be carried out without dust and debris. The professional tool is equipped with a pair of diamond discs, thanks to which you can cut both lines at once. The width and depth of the gates are set independently, depending on the required and permissible standards, parameters.
Professional equipment of this kind should only be used by qualified personnel. The quality of the work performed and the safety in their performance depend on this.
Final stage
After the gating process is over, the wire is laid, the final stage of replacing the wiring begins. Shtrob putty is an equally important stage. Professionals in their field know the intricacies of this stage, but not everyone is conscientious about it. If the customercontrols the whole process, he must pay special attention to which layer of putty is applied. Qualified professionals apply it in thin layers and wait for complete drying before applying the next layer. This happens until the thickness of the material is equal to the level of the surface.
The first sign that the requirement for complete drying of the layers was not observed is the uneven surface of the strobe. The color of dry putty should be identical to the shade of the wall. When pasting the walls with wallpaper, you will not see the places where the strobes were previously. If the color of the wall and the puttied strobe differ, it will be noticeable through thin wallpaper.
The result depends only on the experience of a specialist. Surface chasing is a very time-consuming and responsible process that only a professional can perform with high quality. In matters of wiring replacement, no mistakes should be made, otherwise they can lead to disastrous consequences.
