The dishwasher is a great help to the hostess in the kitchen, as there is no escape from dirty dishes. German technology is famous for its high quality, but even it sometimes fails. Let's figure out what the Bosch dishwasher error E15 warns about, and also offer ways to fix the problem yourself.
How to decipher the warning from the typewriter?
When equipment malfunctions, the thought immediately comes to mind that a breakdown may require expensive and lengthy repairs.
But you really don't want to do without electrical assistants again. Therefore, we must learn to understand the warnings of household units ourselves. Error codes are usually indicated in the instruction manual of the device, the manufacturer of the equipment also described the error E15 of the Bosch dishwasher.
In some situations, you will need to get the built-in machine and turn it over. These actions will require time and physical force.
Code E15
This error means that a leakage protection has occurred, called inBosch typewriters with the Aqua-stop system. When the code E15 appears on the display, the system indicates a possible ingress of water into the tray. It is also possible to assume that the float is stuck.
Also, the reasons for the appearance of such a code may be the situation:
- malfunctions of the sensor that controls leakage in the system;
- clogging of the drain system (filters, hoses, sewers);
- wear of nozzles or their depressurization;
- A problem occurs with the water spray system.
The appearance of an error E15 dishwasher Bosch - a common occurrence. Moreover, such a problem can be solved independently, without wasting time and money on calling the master. It is enough to carefully study the further recommendations. Do not forget about safety when working with any electrical appliances.
Ways to fix the problem on your own
You can try to fix the Bosch dishwasher error E15 yourself. To do this, it is recommended to first unplug the power cord. Then you should tilt the body of the unit by 45 degrees. The described manipulations will help in removing water from the pan.
The machine, rid of the liquid, is thoroughly dried. 24 hours after the measures taken, it is necessary to restore the power supply and check the operation of the device. Knowing what to do with the Bosch dishwasher error E15, you can adjust it yourself and use it again at the right time.
Sometimes the E15 code is displayed if too much detergent has been added. As a resultthis creates an excess of foam and leakage occurs. The Aqua-Stop system reacts urgently and reports the problem on the display.
If the above methods have not shown their effectiveness, you need to disassemble the machine and check if it is clogged with food debris. This situation is typical for dishwashers. After removing dirt, you can check the operation of the device again.
Decontamination removal
It is recommended to use gloves, as it is possible to damage the skin of the hands with fragments of broken dishes. The cleaning steps are as follows:
- The door opens.
- Baskets and pallets are being removed.
- A filter comes out from the bottom of the machine.
- Contaminants are removed and the filter is washed under running water.
Drain hose and pump may need to be checked. To do this, the dishwasher body must be turned over and laid down. Then do the following:
- Unscrew the fixing screws of the bottom cover. It is important not to remove it completely, as a float sensor is installed there.
- Open the cover slightly, unscrew the sensor screws. If they are broken, they must be replaced.
- Without the lid, you can get inside the dishwasher.
- Disconnect the hose and pump with pliers.
- Check for blockage or damage. Clean parts with running water or replace parts.
- To test the pump, disconnect the connectors.
- Remove side screws.
- Turn and remove the pump.
- Inspect the impeller,check the gasket for damage and wear.
Important note! If the pump is broken, the repair will have no results. Then you need to purchase and install a new part.
The faucet is on fire
It happens that the Bosch E15 dishwasher error is displayed and the tap is on. There may be several reasons for this. If the equipment works without failures, then there is no cause for concern. So the device reports that water is being pumped.
When the machine is not working and the “faucet” icon is lit, there may be such problems:
- clogged filter through which water enters the system;
- broken or broken water start valve;
- the drain system is incorrectly connected, and the water is automatically drained from the machine;
- faulty spray chambers;
- There was a problem with the Aqua Stop system.
Depending on the model of the dishwasher, it has a full or partial system that provides protection against leaks.
In machines where full protection is installed, the float sensor is triggered. The display then reports the problem by flashing the fault code.
In case of partial protection, the inlet hose is equipped with an absorbent sponge. When this material absorbs a lot of water, the system simply stops working, as it is clogged with a filled sponge.
Trying to cope on our own
The article discusses the Bosch dishwasher. howto eliminate the dishwasher error E15 in case of problems with the Aqua-stop system? Let's talk about it further.
If sticking of the sensor on the pallet is excluded, it is recommended to inspect the body and the quality of the hose connection. If no problems are identified, you can try to perform the following manipulations:
- The dishwasher must be unplugged from the power supply.
- By tilting the body of the machine, try to ensure the float is in the correct position within the normal range.
- If water is found in the pan, it must be removed.
- The car needs to dry.
As you can see, the way to fix the "burning faucet" problem is similar to the methods for fixing error code E15.
When mechanical protection is triggered, a complete hose replacement will be required.
Error E15 in the Bosch SMV 69T40 dishwasher can be fixed in the same way as in other models. This economic equipment is supplied with reliable system of protection against leaks of full type. Therefore, a problem in Aqua-Stop will be reported by a display that glows with an error code. Also, this model of dishwasher is characterized by high energy saving capabilities.
Replacing the sprinkler
Despite its reliability, even German Bosch appliances are subject to wear and tear. In case of problems with the sprinkler, it must be replaced without fail. To do this, perform the following actions:
- take out the basket in which the dishes are placed;
- unscrew the part of the lower water sprinkler;
- grabbing and twistingmount;
- twist new fasteners and install a replacement sprinkler.
Changing the upper rocker
In order to replace the upper rocker, you must:
- Press the stop and carefully pull out the upper basket.
- Find the rocker pinned at the bottom of the basket.
- Pull out the part to remove from the place where it is usually located.
- Install new rocker.
Summarize
The article suggested ways to fix problems with the dishwasher yourself if the display shows a faucet or error code E15.
If Bosch dishwasher error E15 is detected and the “faucet” icon is on, and the above troubleshooting solutions do not help, you should seek professional help.
