Once upon a time, mankind invented such a thing as plastic storm water inlets. They are widely used in private yards, just on the streets of large and small cities, in areas of enterprises and factories. They have many varieties and interpretations, but their main function is the same - the collection of rain or melt water, as well as other liquid waste that is on the sidewalks or drains from the roof. Often, plastic storm water inlets are connected to a downpipe, through which all the liquid and melted snow enter them.
As mentioned above, this discovery of mankind has many varieties. Depending on the location, the type of storm water inlet, its dimensions, weight and endurance are selected. Indeed, some gratings are mounted in private yards and connected to a drainpipe, others are located directly on the roadway, and others - on sidewalks and alleys. And also theirmust be mounted near factories and plants, where it is necessary to strictly adhere to safety regulations.
All plastic gutters are made from an adapted material that can withstand the weight and dynamics of the car passing over it. They are divided into four categories, which differ in load class, total mass, size and other parameters. For example, a plastic storm water inlet 300x300 fits the A-C load class and has a mass of 2.5 kilograms. This is one of the most common containers, so it can be found both in the city and in a private courtyard. It is followed by tanks with parameters 400 x 400 and 550 x 550, with a weight of 3.5 kg and 7 kg, respectively. Most often they can be seen in the area of factories.
Plastic storm water inlets are always connected to the sewer channel. Water, getting into them, is first in a small container, which is located under the main grate, and then is discharged into common pipes. Often, along with the liquid, street debris also gets there, which can accumulate on the walls of the container and rot. These containers are equipped with special filters, and housing office workers must certainly clean them. Plastic storm water inlets, which are located in private properties, work on the same principle, and the owners themselves are obliged to monitor their cleanliness.
It is also important that the grill, which is a kind of "lid" of such a system, is firmly fixed in place. There shouldn't be locks or clips, it just needs to bethe edges of the protective part and the reservoir fit snugly against each other. Given this condition, any plastic storm water inlet will serve you for a very long time. The price for it will depend on the size and characteristics of the material, but in any case, this indicator will remain acceptable and affordable (the cost varies between 10-100 dollars).
The foundations of irrigation were laid by such an ancient people as the Sumerians. Those people understood that it was important not only to competently supply water to the city, but also to “withdraw” everything superfluous from there just as competently. Therefore, when choosing plastic storm water inlets, you should pay attention to their quality, shelf life and the material that underlies the entire structure.
